Quick Answer: How To Remove Ball Joint Without Pickle Fork?

What can I use instead of a pickle fork?

Yep, all you need is a big hammer. Once I got the knuckle free from the beam (using a hammer), I put the knuckle in a large vice and beat the ball joints out with the hammer.

How do you loosen a tight ball joint?

Sand it a bit. edit- The ball itself. yep, best way is to get the ball out the joint then sand the ball lightly, then refit the fall and if it is still too tight try again, it’s easy enough to just tighten it again.

What is a pickle fork tool?

The most commonly known tool for separating ball joints is the pickle fork. To use a pickle fork, simply slide it between the spindle and the control arm as tight as you can and then hit the free end with a hammer. This drives the wedge between the two points and forces the joint out of the taper.

Can you replace ball joints yourself?

Can You Replace Your Ball Joint? If you feel comfortable doing your own car maintenance, you can replace ball joints yourself. This can be accomplished using a tool called a ball joint press (Available through Loan-A-Tool).

What is the best ball joint removal tool?

Astro Pneumatic 7897 Ball Joint Tool Kit



Most professional mechanics prefer the Astro 7897 Ball joint Tool Kit due to its durability. It is ideal when removing or installing ball joints, universal joints, and truck brake anchor pins. Having been made from heavy-duty steel material, it will last for many years.

Can you hammer in ball joints?

you can hammer it out, but DO NOT hammer it back in, you will damage it and it will wear out prematurely. Even with a brass drift it will damage it. Get a ball joint press or take your knuckle off and take it to a shop with a press to press in the new one.

How do you remove tie rods from knuckles?

Using a BFH (Big F-ING Hammer), hit the steering knuckle right on the end, directly in line with the arm. Leave the jack in place and don’t be afraid of it. Hit it like you mean it. The tie rod end should pop free of the knuckle arm in two or three whacks.

Can ball joints cause stiff steering?

Steering – Worn ball joints can affect your vehicle’s steering, usually making the steering sloppy or stiff depending on how the ball joint is wearing. However, if both edges are wearing out faster than the middle, the problem is not ball joints, but under-inflation of your tires.

What happens if you over tighten ball joints?

Improper torquing will cause looseness that may eventually cause joint stud breakage and damage to the steering knuckle. Also, looseness due to improper torquing may produce the same symptoms as a defective ball joint and may lead to unnecessary replacement.

How long does it take to replace ball joints?

The ball joint is a small part of your car, and the part itself is only going to cost between $20-$150 or more, depending on where you get it from and what kind of vehicle you own. It can take a little over an hour to get it replaced, so the full ball joint replacement cost will be between $100 and $400.

Leave a Reply

Your email address will not be published. Required fields are marked *